Netgear Technical Support Lays The Tips To Position The router
While adding the access points to the fresh deployment, it is important to place the point of access in the correct position. The location of your AP is always in the location where the Wi-Fi signal is the strongest. If you move far away from the subject, the weaker the signal becomes assuming no surface absorbs or blockage. It may make a lot of difference.
Netgear Support lays down the method to fix your issue
Keep your router off the ground so that the signals aren’t broadcasted in a downward position.
To access to a wireless network once the router is out of sight, networks may require an installation of additional access point or extenders to perpetuate the signals further.
Move for checking the directions of the signal before you choose where you need to position your AP. In case it is Omni-directional and wall mountable, position your strength per room at the center, to have the proportionate strength.
Don’t place the access points inside the cabinet where your structure of walls or the cabinet doors block the signals.
Keep your router away from the other electronic devices as they can interfere with the router.
Make the antenna face in a different direction to enable the communication between the systems, irrespective of the position. In case the router has too many antennas, it can be placed strategically to pair with the antenna positioning in its networks. Just in case, consider that while laptops have a horizontal antenna, the direction of internal depends on how the device is held.
In case your device has more than 1 pointing, keep the power low and set it over the different channels in order to avoid interference. You can set your channel to auto.
With these steps, you must be able to have a well-configured connection with your Netgear router. For further assistance, contact us via Netgear Router Support Australia 1-800-954-282 and get satisfied against any related problem.